Buttonhole Stitching 77
GETTING READYCONTENTS SEWING BASICS UTILITY STITCHES APPENDIX INDEX
Buttonhole sewing
The maximum buttonhole length is about 28 mm (1-1/8 inch) (diameter + thickness of the button).
Buttonholes are sewn from the front of the presser foot to the back, as shown below.
The names of parts of buttonhole foot “A”, which is
used for sewing buttonholes, are indicated below.
1 Button guide plate
2 Presser foot scale
3 Pin
4 Marks on buttonhole foot
5 5 mm (3/16 inch)
1
Use chalk to mark on the fabric the position
and length of the buttonhole.
1 Marks on fabric
2
Pull out the button guide plate of buttonhole
foot “A”, and then insert the button that will
be put through the buttonhole.
1
1
1
1
1 Reinforcement stitching
A
1
2
5
3
4
1
S3_brotherE.book Page 77 Thursday, May 15, 2003 1:58 PM
To Next Page
Loading...
Need help?
General
