Brother DCP-110C Quick Setup Guide

28
■ For Network Users (DCP-310CN only)
This section is for using the machine on a network. An administrator should set up the machine
using the following steps.
To restore all network settings of the internal Print/Scan server to factory default, please follow
the steps below.
1
Make sure the machine is not operating, then disconnect all the cables from the machine (except
power cable).
2
Press Menu.
3
Press
▲
or
▼
to select 3.LAN.
Press Set.
4
Press
▲
or
▼
to select 0.Factory Reset.
Press Set.
5
Press
▲
to select 1.Reset.
6
Press
▲
again to select 1.Yes.
7
The machine will restart, re-connect cables once this is complete.
Network User's Guide Chapter Map
Windows
®
98/Me Peer-to-Peer TCP/IP Chapter 4 Network Printing from Windows
®
Windows
®
2000/XP Peer-to-Peer TCP/IP Chapter 4 Network Printing from Windows
®
Macintosh
®
TCP/IP Chapter 5 Network Printing from Macintosh
®
OS2 Warp Server, LAN Server TCP/IP Chapter 4 Network Printing from Windows
®
Restoring the Network Settings to Factory Default

Brother DCP-110C Specifications

General

Brand	Brother
Model	DCP-110C
Category	All in One Printer
Language	English