Brother DCP-1623W

 
1-21-2
 Confidential Confidential

OthersOthers
(1(1)) CoCondndenensasatitionon
When the machine is moved to a warm room from a cold location, condensation mayWhen the machine is moved to a warm room from a cold location, condensation may
occur inside the machine, causing occur inside the machine, causing various problems as listed below.various problems as listed below.
•• CondenCondensation osation on the surfacn the surface of opticae of optical devicel devices such as the ls such as the lens, reflens, reflecting mecting mirror andirror and
protection glass may cause light print image.protection glass may cause light print image.
•• If the expoIf the exposure drusure drum is cold, thm is cold, the electrie electrical resical resistancstance of the phote of the photosensiosensitive laytive layer iser is
increased, making it impossible to increased, making it impossible to obtain the correct print density.obtain the correct print density.
•• CondenCondensation on sation on the chargthe charge unit may cae unit may cause corouse corona charge lna charge leakage, reakage, resultinesulting ing in
image defects.image defects.
•• CondenCondensation sation on the on the plate mplate may cauay cause pase paper feper feed probed problems.lems.
If condensation has formed in the machine, leave the machine for at least two hours untilIf condensation has formed in the machine, leave the machine for at least two hours until
it reaches room temperature.it reaches room temperature.
If the drum unit is unpacked soon after it is moved to a warm room from a cold location,If the drum unit is unpacked soon after it is moved to a warm room from a cold location,
condensation may occur inside the unit which may cause printing failure.condensation may occur inside the unit which may cause printing failure.
Leave the drum unit for one or two hours until it reaches room temperature, and thenLeave the drum unit for one or two hours until it reaches room temperature, and then
unpack it.unpack it.
(2(2)) LoLow tew tempmpereratatururee
The motor may not operate normally in a cold environment because too much load isThe motor may not operate normally in a cold environment because too much load is
applied to each drive. In this case, increase the room temperature.applied to each drive. In this case, increase the room temperature.

CleaningCleaning
Use a soft lint-free cloth.Use a soft lint-free cloth.
WARNING
WARNING
DO NOTDO NOTuse any use any flammable spray or flammable solvent such as alcohol, benzine,flammable spray or flammable solvent such as alcohol, benzine,
or thinner to clean the or thinner to clean the machine.machine. DO NOTDO NOTuse these articles use these articles near the machine.near the machine.