Brother DCP 585CW - Color Inkjet - All-in-One - Page 82

Wireless Configuration for Macintosh
®
using the Brother installer application (Not available for MFC-5490CN and MFC-5890CN)
72
5
k To communicate with the un-configured wireless machine, temporarily change the wireless settings on
your computer to match the machine’s default settings shown on this screen. Check the box after you
confirm these settings, and then click Next.
Note
You can temporarily change the wireless settings on your computer, following the steps below:
1 Click the AirPort status icon and select Open Internet Connect...
2 Click the Network tab to see the available wireless devices. You can see the Brother wireless print
server in the Network option. Select SETUP.
3 Your wireless network is connected successfully.
l Choose the machine you wish to configure, and click Next. If the list is blank, check if the machine is
powered on, and then click Refresh.
Note
The default Node name is “BRWxxxxxxxxxxxx” (where “xxxxxxxxxxxx” is your Ethernet address).