Control panel setup
79
6
For Touchscreen models 6
a Press MENU.
b Press Network.
c (For Wired) Press Wired LAN.
(For Wireless) Press WLAN.
d Press TCP/IP.
e Press IP Address.
f Enter the IP address.
g Press OK.
h Press Stop/Exit.
Subnet Mask 6
This field displays the current subnet mask used by the machine. If you are not using DHCP or BOOTP to
obtain the subnet mask, enter the desired subnet mask. Check with your network administrator for the subnet
mask to use.
a Press Menu.
b Press a or b to choose Network.
Press OK.
c (For Wired) Press a or b to choose Wired LAN.
(For Wireless) Press a or b to choose WLAN.
Press OK.
d Press a or b to choose TCP/IP.
Press OK.
e Press a or b to choose Subnet Mask.
Press OK.
f Enter the Subnet Mask address.
Press OK.
Note
For DCP models, press a or b repeatedly to enter the first three-digit number for the Subnet Mask. Press
c to enter the second three-digit number. Repeat this step until you have entered the fourth three-digit
number to complete the Subnet Mask. Press OK.
g Press Stop/Exit.
To Next Page
Loading...
