2-26
Confidential
Replace Parts PF Kit 1
Printable pages set for paper feeding kit 1 have
reached the limit. (Printing does not stop.)
5200 2-36
Replace Parts PF Kit 2
Printable pages set for paper feeding kit 2 have
reached the limit. (Printing does not stop.)
5300 2-36
Replace Parts PF Kit
MP
Printable pages set for the MP paper feeding kit
have reached the limit. (Printing does not stop.)
5100 2-36
Replace Toner
The toner sensor detected no toner remaining
or the number of rotations of the developer
roller has reached the upper limit.
6300 2-39
Scanner Error
The voltage value was above the upper limit
during scanning.
B700 2-58
The voltage value was below the lower limit
during scanning.
B800 2-58
The white level does not increase during
scanning although the light intensity was
increased.
B900 2-58
A white level not within the standard was
scanned when function code 55 was executed.
BB00 2-59
A black level not within the standard was
scanned when function code 55 was executed.
BD00 2-59
Self-Diagnostic
Rechecking the error after the power switch
was turned OFF and then ON again because
an error was detected by the center thermistor
of the fuser unit.
(This message is displayed for approximately
15 minutes when the machine is restarted after
error code 5800 has occurred.)
5900 2-38
Size Error
When printing from paper tray 1, a paper size
not supported for paper tray 1 was specified
from the driver.
9700 2-51
When printing from paper tray 2, a paper size
not supported for paper tray 2 was specified
from the driver.
9800 2-51
Size Error DX
The registration front sensor detected that the
paper fed was smaller than or larger than the
specified size in duplex printing mode.
8900 2-46
Printed on a paper size not supported for
duplex printing was specified from the driver.
9900 2-51
Size Mismatch
The registration front sensor detected that the
paper length was too short when faxing or
printing a list or report.
8000 2-43
When printing from the MP tray, the size of
paper set in the MP tray does not match the
size specified by the driver.
9000 2-48
When printing from paper tray 1, the size of
paper set in paper tray 1 does not match the
size specified by the driver.
9100 2-48
When printing from paper tray 2, the size of
paper set in paper tray 2 does not match the
size specified by the driver.
9200 2-48
Toner Low
The toner sensor detected that the toner
remaining has fallen below the specified level
or the developer roller counter has exceeded
the specified value.
6700 2-39
Error Message Description
Error
codes
Refer
to:
To Next Page
Loading...
Need help?
General
Weight and Dimensions
