Brother DCP-J140W

50
3.Network
(Continued)
3.WPS/AOSS — — You can easily configure
your wireless network
settings using the one-
button push method.
See .
4.
WPS w/PIN Code — — You can easily configure
your wireless network
settings using WPS with
a PIN code.
5.WLAN Statu s 1. Status Active(11b)
Active(11g)
Active(11n)
AOSS Active
Connection Fail
You can see the current
wireless network status.
2.Signal — You can see the current
wireless network signal
strength.
3.SSID — You can see the current
SSID.
4.Comm. Mode — You can see the current
Communication Mode.
6.MAC Addres s — — You can see your
machine’s MAC address
from the control panel.
7.WLAN Enabl e — On
Off*
Lets you use the wireless
network connection.
0.
Network Reset — — Restore all network
settings to the factory
settings.
Level1 Level2 Level3 Options Descriptions Page
See Network User’s Guide.
The factory settings are shown in Bold with an asterisk.