2
2
Attachment of the cover
of the control panel
a Attach the cover of the control panel to the
machine.
3
Load plain A4 paper
a Pull the paper tray completely out of the
machine.
b Open the output paper tray cover.
c With both hands, gently press and slide the
paper side guides a and then the paper length
guide b to fit the paper size.
Make sure that the triangular marks c on the
paper side guides a and paper length guide b
line up with the mark for the paper size you are
using.
d Fan the stack of paper well to avoid paper jams
and misfeeds.
e Check that the paper is flat in the tray.
f Gently adjust the paper side guides to the
paper with both hands.
g Close the output paper tray cover.
h Slowly push the paper tray completely into the
machine.
i While holding the paper tray in place, pull out
the paper support until it clicks, and then unfold
the paper support flap.
Always make sure that the paper is not curled or
wrinkled.
Be careful that you do not push the paper in too
far; it may lift at the back of the tray and cause
paper feed problems.
To Next Page
Loading...
