Brother DCP-J140W

14
For Wireless Network Users
12
Manual configuration
from the control panel
(Windows
®
and
Macintosh)
a On your machine, press Menu.
Press a or b to choose 3.Network and press
OK.
Press a or b to choose 2.Setup Wizard and
press OK.
When WLAN Enable? is displayed, press a to
accept.
This will start the wireless setup wizard.
To cancel, press Stop/Exit.
b The machine will search for available SSIDs. It
will take several seconds to display a list of
available SSIDs.
If a list of SSIDs is displayed, press a or b to
choose the SSID you wrote down in step 11-b
on page 11, then press OK.
If the wireless access point/router of the
selected SSID supports WPS and the machine
asks to use WPS, press a (Next) and go to c .
If the machine asks you to enter a Network
Key, go to d.
Otherwise, go to e.
c Press a (Yes) to connect your machine using
WPS. (If you choose b (No) to continue manual
setting, go to d to enter a Network Key.)
When the LCD shows Press WPS on rtr,
press the WPS button on your wireless access
point/router, and then press a (Next) and
a (Yes) to proceed.
Go to e.
d Enter the Network Key you wrote down in
step 11-b on page 11 using the a, b keys to
choose each letter or number.
Use Enlarge/Reduce key or Number of
Copies key to move the cursor left or right.
For example, to enter the letter a, press the a
key once. To enter the number 3, hold down
the a key until it appears.
The letters appear in this order: lower case,
upper case, numbers and then special letters.
Press OK when you have entered all the
characters, then press a (Yes) to apply your
settings.
e Your machine will now try to connect to your
wireless network. It may take a few minutes.
f A connection result message appears for
60 seconds on the LCD and a wireless LAN
report will automatically be printed.
Wireless setup is now complete.
To install MFL-Pro Suite, continue to
step 13.
For Windows
®
Users:
Now go to
Page 15
For Macintosh Users:
Now go to
Page 17
Note
• If a list of SSIDs is not displayed, make sure
your access point is on. Move your machine
closer to the access point and try starting
from a again.
• If your access point is set to not broadcast the
SSID, you will have to manually add the SSID
name. For details, see the Network User’s
Guide.