Brother DCP-J315W - Adjusting Density; Setting Your Changes as a New Default

Making copies
7
3
Place your document face down in the
direction shown below.
 2in1(P)
 2in1(L)
 4in1(P)
 4in1(L)
 Poster(3 x 3)
You can make a poster size copy of a
photograph.
Adjusting Density 3
You can adjust the copy density to make
copies darker or lighter.
a Load your document.
b Enter the number of copies you want.
c Press a or b to choose Density.
Press OK.
d Press d or c to make a lighter or darker
copy.
Press OK.
e If you do not want to change additional
settings, press Mono Start or
Colour Start.
Setting your changes as a
new default 3
You can save the copy settings for Quality,
Enlarge/Reduce, Density and
Page Layout that you use most often by
setting them as the default settings. These
settings will stay until you change them again.
a Press a or b to choose your new setting.
Press OK.
Repeat this step for each setting you
want to change.
b After changing the last setting, press
a or b to choose Set New Default.
Press OK.
c Press + to choose Yes.
d Press Stop/Exit.