Brother DCP-J315W - Enlarging or Reducing the Copied Image

Making copies
5
3
Enlarging or reducing the
copied image 3
You can choose an enlargement or reduction
ratio. If you choose Fit to Page, your
machine will adjust the size automatically to
the paper size you set.
a Load your document.
b Enter the number of copies you want.
c Press a or b to choose
Enlarge/Reduce.
Press OK.
d Press a or b to choose 100%, Enlarge,
Reduce, Fit to Page,
Custom(25-400%).
e Do one of the following:
 If you chose Enlarge or Reduce
press OK and press a or b to choose
the enlargement or reduction ratio
you want. Press OK and go to
step f.
 If you chose Custom(25-400%),
press OK. Press a, b, d or c to select
a number, and then press OK
repeatedly until you complete to
enter the number.
Press a, b, d or c to select , and
press OK. Go to step f.
 If you chose 100% or Fit to Page,
press OK. Go to step f.
f If you do not want to change additional
settings, press Mono Start or
Colour Start.
Note
• Page Layout is not available with
Enlarge/Reduce and Fit to Page.
• Fit to Page does not work correctly if
the document on the scanner glass is
skewed by more than 3 degrees. Using
the document guidelines on the left and
top, place your document in the upper left
hand corner, with the document face down
on the scanner glass.
OK
OK
198% 10x15cmiA4
186% 10x15cmiLTR
142% A5iA4
100%
97% LTRiA4
93% A4iLTR
83%
69% A4iA5
47% A4i10x15cm
Fit to Page
Custom(25-400%)