Brother DCP-J515W - Page 20

Chapter 4
16
Enhance Scenery 4
Enhance Scenery is best used for adjusting
landscape photographs. It highlights green
and blue areas in your photo, so that the
landscape looks more sharp and vivid.
a Make sure you have put the memory
card or USB Flash memory drive in the
correct slot.
Press (PHOTO CAPTURE).
b Press a or b to choose
Enhance Photos.
Press OK.
c Press d or c to choose your photo.
Press OK.
d Press a or b to choose
Enhance Scenery.
Press OK.
e Do one of the following:
 Press OK if you do not want to
change any settings.
 Press a or b to adjust the effect level
manually. Press OK when you have
finished.
f Press + or - repeatedly to enter the
number of copies you want.
g Do one of the following:
 Press OK and change the print
settings. (See PhotoCapture
Center™ print settings on page 20.)
 If you do not want to change any
settings, press Colour Start to print.
Remove Red-Eye 4
The machine detects eyes in your photos and
will attempt to remove red-eye from your
photo.
Note
There are some cases when red-eye may
not be removed.
• When the face is too small in the
image.
• When the face is turning too far up,
down, left or right.
a Make sure you have put the memory
card or USB Flash memory drive in the
correct slot.
Press (PHOTO CAPTURE).
b Press a or b to choose
Enhance Photos.
Press OK.
c Press d or c to choose your photo.
Press OK.
d Press a or b to choose
Remove Red-Eye.
Press OK.
 When Remove Red-Eye is
successful, the photo with the effect
is shown. The adjusted part is shown
in a red frame. Press OK.
 When Remove Red-Eye is
unsuccessful,
Unable to Detect. is shown.
Press OK to go back to the previous
level.
Note
Press a to try Remove Red-Eye again.
e Press + or - repeatedly to enter the
number of copies you want.