Brother GTX Series - Heat Press and Dryer Settings; Pre-Treatment Drying Settings; Ink Curing Settings; Critical Printer Operation: Power ON

VERY IMPORTANT
NEVER POWER OFF THE PRINTER !
The Brother GTX should ALWAYS be left with Power ON
NEVER shut OFF the printer except if requested by the display informations !
Power is requested to perform the needed recirculation of the inks from time to time
POWER
3
HEAT PRESS SETTINGS for Pre-Treatment DRYING
HEATPRESS & TUNNEL DRYER SETTINGS for INK CURING
Check the Real Temperature with a Probe or with Strips to be sure that you are safe for washability!
Add an Open-cells silicon sheet under the T-shirt to extract steam more easily and to have even PT layer
35
Seconds
Pre
Treatment
1/2 distilled
water
5 - 5,5
Bars
75 - 80
PSI
180°C
360°F
35
Seconds
Pre
Treatment
1/2 distilled
water
5 - 5,5
Bars
75 - 80
PSI
180°C
360°F
35
Seconds
3,30
Minutes
Ink
Curing
0,7 - 1,4
Bars
10 - 20
PSI
180°C
360°F
160°C
320°F
35
Seconds
3,30
Minutes
Ink
Curing
Ink
Curing
0,7 - 1,4
Bars
180°C
160°C
320°F
10 - 20
PSI
360°F
TUNNEL DRYER
HEATPRESS