Brother HL-1201 - Save Data Command; Save Specified Type

APPENDIX B - FLASH/PCMCIA CARD COMMANDS - 7
3.3 Save Data Command
3.3.1 Save specified type
Command
ESC CR ! 12345F type(4byte) size(4byte) data...
** type = MCRO, DATA
Available Devices
F, A, H
Description
This command saves data of the specified type with the data ID which is set with the ESC & f # Y (Macro
ID Configuration) command.
If there is insufficient memory in the printer to store the data, a memory full error occurs.
When the printer supports two or more storage devices, the command saves the data onto the device specified by
the select storage device command. When only one device is enabled, the command saves onto that device.
Error
HL-1660e/2060/2400C:
34 MEMORY FULL
43 CARD1 W ERROR
43 CARD2 W ERROR
HL-2400Ce/3400CN
43 DEVICE1 W ERROR
43 DEVICE2 W ERROR
43 DEVICE3 W ERROR
HL-2460/3260N/2600CN/3450CN/7050:
43 CARD ERROR
43 HDD ERROR
HL-
1650/1670N/1850/1870N/5070N/5170DN/5270DN/5280DW/5380DN/6180DW/5470DW/5450DN/5440D/S7000DN:
43 SERVICE E74
HL-6050/6050D/6050DN/8050N/2700CN:
43 CARD ERROR