10
Setting Up Your Printer
Do NOT connect the interface cable.
Connecting the interface cable is
done when installing the driver.
1 Make sure that the printer power switch is
off.
2 Connet the AC power cord to the printer,
and then plug the AC power cord into an AC
outlet.
3 Turn the power switch on.
4 After the printer has finished warming up,
the Ready LED stops blinking and stays
green.
5 Press the control panel button. The printer
prints a test page.
Check that the test page has printed
correctly.
4 Print a Test Page
I O
Alarm
Ready
Data
Paper
Toner
Extend the
Support flap.
Drum
Alarm
Ready
Data
Paper
Toner
Go to the next page
to install the driver.
Step 1
To Next Page
Loading...
