Brother HL-4000CN - Page 2

OFF ON
6
Open the Macintosh
HD icon.
1
Connect the USB interface cable to your
Macintosh
®
, and then connect it to the
printer.
1
Click the HL-4000CN icon on the Desktop.
The setup is now complete.
2
Select Set Default Printer from the Printing menu.
Step 6 Connect the Printer to Your Macintosh
®
and Install the Adobe PostScript3 PPD File and AdobePS Driver
Step 5 Set the Adobe Protcol
Step 7 Setting Your Printer as the Default Printer
7
Open the AdobePS
Components folder.
For Mac
®
OS 8.6 to 9.2 Users Only
Step 5 Connect the Printer to Your Macintosh
®
and Install the Adobe PostScript3 PPD File
For Mac
®
OS X 10.1 Users Only
8
Open the Desktop Printer Utility
icon.
9
Select Printer (USB), and
then click the OK button.
12
Click the Create... button.
11
Click the Change... button in USB Printer Selection.
Select HL-4000CN, and then click the OK button.
10
Click the Change... button in PostScript
TM
Printer
Description (PPD) file.
Select Brother HL-4000CN, and then click the Select
button.
13
Enter your printer name (HL-4000CN),
and then click the Save button.
14
Select Quit from the File menu.
5
Follow the instructions on the
screen.
2
Insert the CD-ROM into
your CD-ROM drive.
3
Double-click the Start Here! icon.
Follow the instructions on the
screen.
3
Insert the CD-ROM into your
CD-ROM drive.
Double-click the HL-4000CN
icon.
5
Double-click the PPD_Installer.pkg icon.
Follow the instructions on the screen.
4
Open the Mac OS X folder.
1
Make sure the printer
power switch is on.
2
Connect the USB interface cable to your
Macintosh
®
, and then connect it to the printer.
6
Open the Macintosh HD icon.
7
Open the Applications folder.
Open the Utilities folder.
8
Open the Print Center icon.
9
Click the Add Printer button.
10
Select USB.
12
Select HL-4000CN from the
Printer Model pop-up menu.
13
Click the Add button.
11
Select HL-4000CN.
14
Select Quit Print Center from the Print
Center menu.
The setup is now complete.
4
Click the Install Software icon
on the Menu screen.
Steps 1 to 4 Follow these steps in the Quick Setup Guide first.
Follow the instructions in this guide for your operating system.
Driver Installation Guide
Macintosh
®
For USB Users
Turn the printer off.
Turn the printer back on.
3 seconds later, an asterisk (
*
)
appears.
System1:
Menu
USB6:
Menu
Adobe Prot oco l
USB6:
Adobe Prot oco l
TBCP
*
Adobe Prot oco l
RAW
Reboo t sys t em
to take effect
Adobe Prot oco l
AW
*
Press .
1
Press 5 times.
2
Press .
5
Press .
3
Press .
4
Press .
6
OFF ON
OFF ON
Note: To change the language of the control panel messages, see “Setting Your Language on the Control
Panel” in the Network Quick Setup Guide (the reverse side of the Quick Setup Guide).
7
R
Macintosh
®
Macintosh
®
NETWORK READYNETWORK READY
Ready t o Pr i n t