ABOUT THIS PRINTER 1 - 42
8
After you finish printing, close the face-up output tray.
Caution
Remove each transparency immediately after printing. Stacking the printed transparencies may
cause a paper jam or the transparency to curl.
When you put transparencies in the MP tray, please remember the following:
■ The side to be printed on must be face up.
■ Put the leading edge (top of the transparencies) in first and push it gently into the tray.
■ The top of the transparency stack must be under the maximum paper height guides that are on
both sides of the tray.
To Next Page
Loading...
