2006/05/31
CHAPTER 6 EPSON - 11
Set data MSB to 0
Esc= (27)(61) <1Bh><3Dh>
• This command enables you to set the most significant bit of incoming data bytes to 0.
• This command does not affect data comprising a graphics image or data that defines a downloadable
character.
LPRINT CHR$(27); CHR$(61); 'Set MSB to 0
Set data MSB to 1
Esc> (27)(62) <1Bh><3Eh>
• This command enables you to set the most significant bit of incoming data bytes to 1.
• This command does not affect data comprising a graphics image or data that defines a downloadable
character.
LPRINT CHR$(27); CHR$(62); 'Set MSB to 1
Cancel MSB setting
Esc# (27)(35) <1Bh><23h>
This command cancels the two commands that set the most significant bit of incoming data bytes (Esc =
and Esc >).
LPRINT CHR$(27); CHR$(35); 'Cancel MSB setting
Select Near Letter Quality or Draft
Escxn (27)(120)n <1Bh><78h>n
The printer ignores this command.
Select / cancel half speed mode
Escsn (27)(115)n <1Bh><73h>n
The printer ignores this command.
Enable printer
DC1 (17) <11h>
The printer ignores this command.
Disable printer
DC3 (19) <13h>
The printer ignores this command.
Initialize printer
Esc@ (27)(64) <1Bh><40h>
• This command resets the printer.
• All remaining data is printed out and the printer default settings are restored.
LPRINT CHR$(27); CHR$(64); 'Printer reset
To Next Page
Loading...
Need help?
General