2006/05/31
CHAPTER 2 "PCL" - 23
4.1.11. Reset to factory default settings
EscCRFD (27)(13)(70)(68) <1Bh><0Dh><46h><44h>
• This command causes a factory reset to be performed, restoring all the printer’s factory default settings. See
the section “Factory default environment” for a list of the factory default settings.
• You can also perform a factory reset using the printer’s control panel or remote printer console program (see
the User Guide).
4.1.12. Reset to user settings
EscCR!#R (27)(13)(33)#(82) <1Bh><0Dh><21h>#<52h>
• # can be 0, 1 or 2.
• #0 indicates the current settings are restored. Unlike the Esc E reset command, the Esc CR!0R command
resets the input buffer.
• #1 indicates the user settings 1 are restored, if the printer supports multi user settings.
• #2 indicates the user settings 2 are restored, if the printer supports multi user settings (Except for HL-7050).
• Depending on the model, you may be able to lock the control panel settings (“SETTING LOCK=ON”). In
that case, parameters 1 and 2 are ignored.
4.1.13. Printer self test
Escz (27)(122) <1Bh><7Ah>
A printer self test causes a test sheet to be printed out to show that the machine is working properly. Depending
on the model, you may also see the test pattern for HRC setting.
4.1.14. Exit current emulation mode
Esc%-12345X (27)(37)(45)(49)(50)(51)(52)(53)(88)
<1Bh><25h><2Dh><31h><32h><33h><34h><35h><58h>
• When the printer receives this command, all page data already received is printed out.
• All settings are reset to the user settings.
• Exits the current emulation mode.
To Next Page
Loading...
