Brother HL-5280DW - PJL Staple On;Off; PS Staple On;Off

2006/05/31
APPENDIX E REFERENCE LIST OF FS-5050 SERIES UNIQUE COMMANDS - 5
3.1.4. PJL staple on/off
Format
@PJL SET/DEFAULT STAPLE=StapleName
Parameter
StapleName*
• UPPER LEFT: Select the upper left of the Finisher/Stapler unit
• UPPER RIGHT: Select the upper right of the Finisher/Stapler unit
• LOWER LEFT: Select the lower left of the Finisher/Stapler unit
• LOWER RIGHT: Select the lower right of the Finisher/Stapler unit
• OFF:
Default = UPPER LEFT
Explanation
• This command selects the staple.
• This command is ignored when the Finisher/Stapler unit is not available.
• The difference between the SET and DEFAULT selection and the effective period of this setting follow the
PJL specifications.
3.1.5. PS staple on/off
Command
<</BRStaple #>>setpagedevice
Parameter
#
• 0: Select off of the Finisher/Stapler unit.
• 1: Select the upper left of the Finisher/Stapler unit.
• 2: Select the upper right of the Finisher/Stapler unit.
• 3: Select the lower left of the Finisher/Stapler unit.
• 4: Select the upper right of the Finisher/Stapler unit.
Default = 0
Explanation
• This command selects the staple.
• This command is ignored when the Finisher/Stapler unit is not available.
<Example>
<</BRStaple 0>>setpagedevice