9
8
Set up the TAD
You must record an outgoing message in order to use
the TAD mode.
a Record the TAD outgoing message
(TAD Message).
b Activate TAD mode.
Press . The button will light when the mode
is active.
9
Set the LCD contrast
(If needed)
If you are having difficulty reading the LCD, try
changing the contrast setting.
a Press MENU.
b Press a or b to display General Setup.
c Press General Setup.
d Press a or b to display LCD Settings.
e Press LCD Settings.
f Press LCD Contrast.
g Press Light, Med or Dark.
h Press Stop/Exit.
10
Set the date and time
The machine displays the date and time, and if you
set up the station ID, the date and time displayed on
your machine will be printed on every fax you send.
a Press MENU.
b Press a or b to display Initial Setup.
c Press Initial Setup.
d Press Date&Time.
e Enter the last two digits of the year on the
Touchscreen, and then press OK.
(e.g. Enter 0 8 for 2008.)
f Repeat for Month and Day, and Hours and
Minutes in 24-hour format.
g Press Stop/Exit.
See Outgoing message (OGM) in Chapter 9
of the User’s Guide.
If the TAD Mode is on, it overrides your
Receive Mode setting. The built-in digital
TAD answers voice calls. If the call is a fax,
you can receive a fax automatically. For
details, see Digital TAD in Chapter 9 of the
User’s Guide.
Note
You can also adjust the angle of the display by
lifting it.
Year:2008
Date&Time
To Next Page
Loading...
