Brother MFC-J2720 - Page 203

3-73
Confidential
(6) Remove the CR timing belt from the Head/carriage unit.
Fig. 3-74
Note: When storing the removed Head/carriage unit for a long period, store the unit in
a Head casing as shown below. Leaving it out of the casing causes the head nozzles
and ink supply ports to dry up so that the Head/carriage unit can no longer provide the
original performance.
Fig. 3-75
CR timing belt
Head/carriage
unit
Latch
Head casing (lower)
Head joint rubber
Joint cap
Head casing (upper)
Head/carriage unit