Chapter 8
64
Color Enhancement (True2Life™) 8
You can turn on the color enhancement
(True2Life™) feature to print more vivid
images. Printing time will be slower.
a Open the media slot cover.
b Put the memory card or USB Flash
memory drive in the correct slot.
c Press Photo.
d Swipe left or right to display
View Photos.
e Press View Photos.
Press OK.
f Swipe left or right, or press d or c to
display each photo. When the photo you
want is displayed, press it and then
press OK.
g Press OK.
h Press Print Settings.
i Swipe up or down, or press a or b to
display Color Enhance.
j Press Color Enhance.
k Do one of the following:
If you want to customize the
White Balance, Sharpness or
Color Density, press
Color Enhance and then press
On.
Go to step l .
If you do not want to customize,
press Color Enhance and then
press Off.
Press .
Go to step o .
l Press White Balance, Sharpness or
Color Density.
m Press d or c to adjust the degree of the
setting.
Press OK.
n Do one of the following:
If you want to customize another
color enhancement, repeat steps l
and m.
Press .
If you want to change other settings,
press to display the print setting
menu and press the setting you want
to change. (See page 61.)
o If you do not want to change additional
settings, press or OK.
Press Start to print.
• White Balance
This setting adjusts the hue of the white
areas of an image. Lighting, camera
settings and other influences will affect the
appearance of white. The white areas of a
picture may be slightly pink, yellow or
some other color. By using this setting,
you can correct that effect and bring the
white areas back to pure white.
• Sharpness
This setting enhances the detail of an
image, similar to adjusting the fine focus
on a camera. If the image is not in true
focus and you cannot see the fine details
of the picture, then adjust the sharpness.
• Color Density
This setting adjusts the total amount of
color in the image. You can increase or
decrease the amount of color in an image
to improve a washed out or weak picture.
To Next Page
Loading...
