Brother MFC-J4710DW

3
e Gently put the paper into the paper tray (for
MFC-J4710DW, tray #1) print side down and
top edge first.
f Gently adjust the paper guides to fit the paper.
Make sure that the paper guides touch the
edges of the paper.
g Check that the paper is flat in the tray and
below the maximum paper mark a. Close the
output paper tray cover.
h Slowly push the paper tray completely into the
machine.
i While holding the paper tray in place, pull out
the paper support a until it clicks, and then
unfold the paper support flap b.
IMPORTANT
Be careful that you do not push the paper in too
far; it may lift at the back of the tray and cause
paper feed problems.
1
NOTE
• For printing and copying on special media,
open the manual feed slot a on the back of the
machine. Feed only one sheet at a time of
Ledger, Legal, A3, envelopes, or thicker paper
when using the manual feed slot.
For details, see Loading paper in the manual
feed slot in chapter 2 of the Basic User’s
Guide.
• (MFC-J4710DW)
For information about tray #2 (the lower tray),
see Loading paper in paper tray #2 in chapter
2 of the Basic User’s Guide.
2
1
1