Chapter 2
16
i Extend Tray #1 over Tray #2 to
prevent printed pages from falling off
the output tray.
1 Pull Tray #1 out of the machine.
2 In the same way you extended
Tray #2, push the blue slider and
extend Tray #1 to Ledger or A3
size, so it is even with Tray #2.
j Open the output paper tray and lift the
A4/LTR stopper (1) if Letter or A4 size
paper is in Tray #1.
k Close the output paper tray cover and
slowly push Tray #1 completely into the
machine.
l Unfold the paper support flap.
m Change the paper size setting in the
machine’s menu, if needed.
(See Set Paper Size and Type
on page 22.)
1
To Next Page
Loading...
