EasyManuals Logo

Brother MFC-J5740DW User Manual

Brother MFC-J5740DW
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
12. Slots and openings in the cabinet and the back or bottom are provided for ventilation; to
ensure reliable operation of the product and to protect it from overheating, these openings
must not be blocked or covered. The openings should never be blocked by placing the
product on a bed, sofa, rug, or other similar surface. This product should never be placed
near or over a radiator or heater. This product should not be placed in a built-in installation
unless proper ventilation is provided.
13. Do not place anything in front of the product that will block printouts. Do not place anything in
the path of received faxes.
14. DO NOT touch a document during printing.
15. Not all telephones will respond to incoming ringing when connected to the extension socket.
(Models with FAX function only)
Models with FAX function only
1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network. It
indicates no endorsement of the product by Telecom, nor does it provide any sort of
warranty. Above all, it provides no assurance that any item will work correctly in all respects
with another item of Telepermitted equipment of a different make or model, nor does it imply
that any product is compatible with all of Telecom’s network services.
2. This equipment does not fully meet Telecom’s impedance requirements. Performance
limitations may occur when used in conjunction with some parts of the network. Telecom will
accept no responsibility should difficulties arise in such circumstances.
3. This equipment should not be used under any circumstances which may constitute a
nuisance to other Telecom customers.
4. This equipment shall not be set up to make automatic calls to the Telecom “111” Emergency
Service.
5. This equipment is not capable, under all operating conditions, of correct operation at the
higher speeds for which it is designed. Telecom will accept no responsibility should
difficulties arise in such circumstances.
6. Some parameters required for compliance with Telecom’s Telepermit requirements are
dependent on the equipment (PC) associated with this device. The associated equipment
shall be set to operate within the following limits for compliance with Telecom’s
Specifications:
There shall be no more than 10 call attempts to the same number within any 30 minute
period for any single manual call initiation.
The equipment shall go on-hook for a period of not less than 30 seconds between the end
of one attempt and the beginning of the next call attempt.
Automatic calls to different numbers are spaced such that there is no less than 5 seconds
between the end of one call attempt and the beginning of another.
Equipment shall be set to ensure that calls are answered between 3 and 30 seconds of
receipt of ringing.
7. Many CPE devices have features such as “last number redial” or “memory dial” which
depend on a small on-hook line current for the maintenance of memory information. Such
terminal devices used with the series connected device may lose their memory functions.
8. Telepermitted equipment only may be connected to the EXT telephone port. This port is not
specifically designed for 3-wire-connected equipment. 3-wire-connected equipment might
not respond to incoming ringing when attached to this port.
16

Other manuals for Brother MFC-J5740DW

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brother MFC-J5740DW and is the answer not in the manual?

Brother MFC-J5740DW Specifications

General IconGeneral
Duplex printingYes
Print technologyInkjet
Maximum resolution1200 x 4800 DPI
Duplex printing modeAuto
Print speed (ISO/IEC 24734) mono28 ipm
Print speed (black, normal quality, A4/US Letter)- ppm
Envelopes sizesCom-10, Monarch
Photo paper sizes9x13, 10x15, 13x18 cm
Paper tray media typesEnvelopes, Photo paper, Plain paper, Recycled paper
Paper tray media weight64 - 220 g/m²
Non-ISO print media sizesIndex card, Legal (media size), Letter (media size)
ISO A-series sizes (A0...A9)A3, A4, A5, A6
Maximum ISO A-series paper sizeA3
Control typeTouch
Product colorWhite
Market positioningHome & office
Scan toE-mail, E-mail Server, FTP, Image, Network folder
Scanner typeFlatbed scanner
Document formats supportedPDF
Optical scanning resolution600 x 600 DPI
Wi-Fi standards802.11a, 802.11b, 802.11g, Wi-Fi 4 (802.11n)
Cabling technology10/100Base-T(X)
Ethernet LAN data rates10, 100 Mbit/s
Mobile printing technologiesApple AirPrint, Mopria Print Service
Near Field Communication (NFC)No
USB 2.0 ports quantity1
Copier resize25 - 400 %
Power consumption (off)0.03 W
Power consumption (ready)5.5 W
Power consumption (sleep)0.9 W
Power consumption (copying)36 W
Energy Star Typical Electricity Consumption (TEC)0.17 kWh/week
Faxing-
Modem speed33.6 Kbit/s
Total input capacity250 sheets
Total output capacity100 sheets
Printing colorsBlack, Cyan, Magenta, Yellow
Duplex functionsCopy, Fax, Print, Scan
Maximum duty cycle2500 pages per month
Mac operating systems supportedMac OS X 10.15 Catalina, Mac OS X 10.15.3 Catalina, Mac OS X 10.7 Lion
Server operating systems supportedWindows Server 2008, Windows Server 2008 R2, Windows Server 2012, Windows Server 2012 R2, Windows Server 2016
Windows operating systems supportedWindows 10, Windows 7, Windows 8
Operating temperature (T-T)10 - 35 °C
Operating relative humidity (H-H)20 - 80 %
Harmonized System (HS) code84433100
Weight and Dimensions IconWeight and Dimensions
Depth398 mm
Width530 mm
Height375 mm

Related product manuals