9. In the event of any problem with this device, it is to be disconnected, and a CPE item
connected to one of its terminal ports may be connected directly in its place. The user should
then arrange for the product to be repaired. Should the matter be reported to Telecom as a
wiring fault, and the fault is proven to be due to this product, a call-out charge will be
incurred by the customer.
10. If a charge for local calls is unacceptable, the “Dial” button should NOT be used for local
calls. Only the 7-digits of the local number should be dialled from your telephone. DO NOT
dial the area code digit or the “0” prefix.
11. This equipment may not provide for the effective hand-over of a call to another device
connected to the same line.
12. This unit will only work in conjunction with a tone signalling (DTMF) telephone, but some
telephones may not be compatible. Since noise or speech from the telephone can upset
dialling from this unit, errors may result if the devices are used together in other than quiet
conditions.
13. Where it is necessary to dial prefix digits, such as a Caller Display override code (“0196” or
“0197”), this unit will have to be used in conjunction with an associated tone signalling
(DTMF) telephone.
14. Note that some telephones are NOT compatible with this unit and dialling errors may result if
the two devices are used together in other than quiet conditions. The Telecom Faults Service
is NOT to be called should such problems arise. In such cases, it is recommended that the
prefix and wanted number are dialled manually.
15. The answer delay setting of this equipment shall not be set to less than the default setting as
this will destroy Caller ID information.
16. The caller ID telephone numbers which are displayed and stored in this equipment include
the caller’s area code or cellular code but do not include the toll access “0” prefix. When
calling back it is necessary to add a “0” to the telephone number, or if the telephone number
is a local number, omit the area code digit. If the toll services of a service provider other than
Telecom are being used then a toll charge may be incurred if the “0” prefix toll access code
and area code are used.
17. When using the Caller Line Identification incorporated in this device, verify the integrity of the
recorded digits prior to dialling.
Important Information for Some Countries
Important Safety Instructions
1. Read all of these instructions.
2. Save them for later reference.
3. Follow all warnings and instructions marked on the product.
4. Unplug this product from the wall outlet before cleaning the outside of the product and the
scanner glass (for the products with scanning functionality). Do not use liquid or aerosol
cleaners. Use a damp cloth for cleaning.
5. Do not place this product near water.
6. Do not place this product on an unstable cart, stand, or table. The product may drop,
causing serious damage to the product.
17
To Next Page
Loading...
Need help?
General
Weight and Dimensions
