Brother MFC-J5955DW User Manual

comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
• Consult with an experienced radio/TV technician for help.
• (Wireless network models only)
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
IMPORTANT
• Changes or modifications not expressly approved by Brother Industries, Ltd. could void the
user’s authority to operate the equipment.
• A shielded interface cable should be used to ensure compliance with the limits for a Class B
digital device.
Compliance with FCC requirement 15.407(c)
Data transmission is always initiated by software, which is the passed down through the MAC,
through the digitaland analog baseband, and finally to the RF chip. Several special packets are
initiated by the MAC. These are the only ways the digital baseband portion will turn on the RF
transmitter, which it then turns off at the end of the packet. Therefore, the transmitter will be on
only while one of the aforementioned packets is being transmitted. In other words, this device
automatically discontinue transmission in case of either absence of information to transmit or
operational failure.
Frequency Tolerance: ±20ppm
RF Exposure Notice (USA or Canada Only) (Wireless Models
Only)
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the
IC radio frequency (RF) Exposure rules. This equipment should be installed and operated
keeping the radiator at least 20 cm or more away from a person's body.
18

Brother MFC-J5955DW Specifications

General

Duplex printing	Yes
Print technology	Inkjet
Maximum resolution	1200 x 4800 DPI
Duplex printing mode	Auto
Print speed (ISO/IEC 24734) mono	25 ipm
Print speed (ISO/IEC 24734) color	16 ipm
Time to first page (black, normal)	4.6 s
Print speed (black, normal quality, A4/US Letter)	30 ppm
Duplex print speed (black, normal quality, A4/US Letter)	21 ppm
Wi-Fi standards	802.11a, 802.11b, 802.11g, Wi-Fi 4 (802.11n)
Cabling technology	10/100Base-T(X)
Security algorithms	64-bit WEP, 128-bit WEP, 802.1x RADIUS, EAP-FAST, EAP-PEAP, EAP-TLS, EAP-TTLS, IPSec, SSL/TLS, WPA-AES, WPA-PSK, WPA-TKIP, WPA2-AES, WPA2-PSK, WPA2-TKIP, WPA3-SAE
Ethernet LAN data rates	10, 100 Mbit/s
Mobile printing technologies	Apple AirPrint, Brother iPrint & Scan, Mopria Print Service
USB connector	USB Type-A
Optional connectivity	Ethernet, Wireless LAN
USB 2.0 ports quantity	2
Sound power level (printing)	6.81 dB
Sound pressure level (printing)	52 dB
Copier resize	25 - 400 %
Maximum copy resolution	600 x 600 DPI
Copy speed (black, normal quality, A4)	25 cpm
Copy speed (color, normal quality, A4)	16 cpm
Display	-
Control type	Buttons, Touch
Product color	White
Display diagonal	3.5 \
Market positioning	Home & office
Power consumption (off)	0.3 W
Power consumption (ready)	6 W
Power consumption (standby)	0.9 W
Power consumption (average operating)	36 W
Energy Star Typical Electricity Consumption (TEC)	0.17 kWh/week
Scanner type	Flatbed & ADF scanner
Optical scanning resolution	1200 x 2400 DPI
Faxing	Color faxing
Modem speed	33.6 Kbit/s
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Printer fonts	PCL
Printing colors	Black, Cyan, Magenta, Yellow
Duplex functions	Copy, Fax, Print, Scan
Maximum duty cycle	3500 pages per month
Number of print cartridges	4
Page description languages	BR-Script 3, PCL 6, PDF 1.7, XPS
Package depth	518 mm
Package width	651 mm
Package height	489 mm
Package weight	23600 g
Total input capacity	500 sheets
Total output capacity	100 sheets
Paper tray 1 input capacity	250 sheets
Auto document feeder (ADF) input capacity	50 sheets
Envelopes sizes	10, C5, Com-10, DL, Monarch
Photo paper sizes	9x13, 10x15, 13x18, 13x20 cm
Paper tray media types	Glossy paper, Plain paper, Recycled paper
Non-ISO print media sizes	Executive (184 x 267mm), Folio (media size), Index card, Legal (media size), Letter (media size)
ISO A-series sizes (A0...A9)	A3, A4, A5, A6
Maximum ISO A-series paper size	A3
Multi-Purpose Tray media weight	64 - 220 g/m²
Harmonized System (HS) code	84433100
Cables included	AC
Server operating systems supported	Windows Server 2012, Windows Server 2016, Windows Server 2019
Windows operating systems supported	Windows 10, Windows 7, Windows 8
Sustainability certificates	Blue Angel, Nordic Swan Ecolabel

Weight and Dimensions

Depth	436 mm
Width	545 mm
Height	375 mm