Chapter 4
26
Remote Retrieval 4
You can call your machine from any
touch-tone telephone or fax machine and
then use the Remote Access Code and
remote commands to retrieve fax messages.
Setting a Remote Access
Code 4
The Remote Access Code lets you access
the remote retrieval features when you are
away from your machine. Before you can use
the remote access and retrieval features, you
have to set up your own code. The factory
default code is the inactive code (--- ).
a Press (Settings).
b Press All Settings.
c Press a or b to display Fax.
d Press Fax.
e Press a or b to display
Remote Access.
f Press Remote Access.
g Enter a three-digit code using numbers
0 to 9, l, or # using the keyboard on the
Touchscreen.
Press OK.
(The preset ‘l’ cannot be changed.)
Do not use the same code as your Fax
Receive Code (l 51) or Telephone
Answer Code (#51). (See Basic User’s
Guide: Using external and extension
telephones.)
h Press .
You can change your code at any time by
entering a new one. If you want to make
your code inactive, press and hold in
step g to restore the inactive setting (---l)
and press OK.
Using your Remote Access
Code 4
a Dial your fax number from a touch-tone
telephone or another fax machine.
b When your machine answers, enter
your Remote Access Code (3 digits
followed by ) at once.
c The machine signals if it has received
messages:
1 long beep — Fax messages
No beeps — No messages
d When the machine gives two short
beeps, enter a command.
The machine will hang up if you wait
longer than 30 seconds to enter a
command.
The machine will beep three times if you
enter an invalid command.
e Press 90 to stop Remote Access when
you have finished.
f Hang up.
• If your machine is set to Manual mode
and you want to use the remote retrieval
features, wait for about 100 seconds after
it starts ringing, and then enter the remote
access code within 30 seconds.
• This function may not be available in some
countries or supported by your local
telephone company.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
