Brother MFC-J895DW - Page 588

Level 1 Level 2 Level 3 Descriptions
Miscellaneous Area Code
(USA only)
- Set your 3-digit area code only if you do not dial it
within your own area code.
[Network]
[Settings] > [All Settings] > [Network]
Level 1
Level 2 Level 3 Level 4 Descriptions
Wired LAN
(MFC-J895DW)
TCP/IP BOOT Method
- Select the BOOT method that best suits
your needs.
IP Address
- Enter the IP address.
Subnet Mask
- Enter the Subnet mask.
Gateway
- Enter the Gateway address.
Node Name
- Enter the Node name.
WINS
Configuration
- Select the WINS configuration mode.
WINS Server
- Specify the IP address of the primary or
secondary WINS server.
DNS Server
- Specify the IP address of the primary or
secondary DNS server.
APIPA
- Set the machine to allocate the IP
address from the link-local address
range automatically.
IPv6
- Turn the IPv6 protocol on or off. For
more information, go to the Brother
Solutions Center at support.brother.com
to see FAQs & Troubleshooting.
Ethernet
- - Select the Ethernet link mode.
Wired Status
- - View the current wired status.
MAC Address
- - View the machine's MAC address.
WLAN TCP/IP BOOT Method
- Select the BOOT method that best suits
your needs.
IP Address
- Enter the IP address.
Subnet Mask
- Enter the Subnet mask.
Gateway
- Enter the Gateway address.
Node Name
- Enter the Node name.
WINS
Configuration
- Select the WINS configuration mode.
WINS Server
- Specify the IP address of the primary or
secondary WINS server.
DNS Server
- Specify the IP address of the primary or
secondary DNS server.
APIPA
- Set the machine to allocate the IP
address from the link-local address
range automatically.
IPv6
- Turn the IPv6 protocol on or off. For
more information, go to the Brother
Solutions Center at support.brother.com
to see FAQs & Troubleshooting.
581