Maximum radio-frequency power transmitted in the frequency band(s): Less than 30 dBm
(e.i.r.p.)
NFC (Models with the NFC Function Only)
This Printer/Multifunction Printer supports NFC (Near Field Communication).
• (HL-L8240CDW/MFC-L3780CDW/MFC-L8390CDW)
Frequency band(s): 13.553 MHz - 13.567 MHz
Maximum radio-frequency power transmitted in the frequency band(s): Less than 111.5
dBuV/m at 10 m
LAN Connection (Models with the Wired LAN Function Only)
CAUTION
DO NOT connect this product to a LAN connection that is subject to over-voltages.
For Models with FAX Function (New Zealand Only)
1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network. It
indicates no endorsement of the product by Telecom, nor does it provide any sort of
warranty. Above all, it provides no assurance that any item will work correctly in all respects
with another item of Telepermitted equipment of a different make or model, nor does it imply
that any product is compatible with all of Telecom’s network services.
2. This equipment does not fully meet Telecom’s impedance requirements. Performance
limitations may occur when used in conjunction with some parts of the network. Telecom will
accept no responsibility should difficulties arise in such circumstances.
3. This equipment should not be used under any circumstances which may constitute a
nuisance to other Telecom customers.
4. This equipment shall not be set up to make automatic calls to the Telecom “111” Emergency
Service.
5. This equipment is not capable, under all operating conditions, of correct operation at the
higher speeds for which it is designed. Telecom will accept no responsibility should
difficulties arise in such circumstances.
6. Some parameters required for compliance with Telecom’s Telepermit requirements are
dependent on the equipment (PC) associated with this device. The associated equipment
shall be set to operate within the following limits for compliance with Telecom’s
Specifications:
• There shall be no more than 10 call attempts to the same number within any 30 minute
period for any single manual call initiation.
• The equipment shall go on-hook for a period of not less than 30 seconds between the end
of one attempt and the beginning of the next call attempt.
14
To Next Page
Loading...
Need help?
General
