Embroidery Applications
E-22
Sewing split embroidery patterns
Split embroidery patterns created with PE-DESIGN Ver.7 or
later, or PE-DESIGN NEXT can be sewn. With split
embroidery patterns, embroidery designs larger than the
embroidery hoop are divided into multiple sections, which
combine to create a single pattern after each section is sewn.
For details on creating split embroidery patterns and for more
detailed sewing instructions, refer to the Instruction manual
included with PE-DESIGN Ver.7 or later, or PE-DESIGN
NEXT.
The following procedure describes how to read the split
embroidery pattern shown below from USB flash drive and
embroider it.
a
Insert the USB flash drive containing the created split
embroidery pattern, and then select the split
embroidery pattern to be embroidered.
• For details on recalling patterns, refer to “Recalling
from USB flash drive” on page E-34.
→ A screen appears so that a section of the split
embroidery pattern can be selected.
b
Select section to be embroidered and press .
• Select the sections in alphabetical order.
• A maximum of 5 sections can be displayed in one
page. If there are 6 or more sections in the pattern,
press or to display the previous or next page.
c
If necessary, edit the pattern, and press .
d
Press .
• For details on editing patterns, refer to “Editing All
Patterns” on page E-15.
e
Press the “Start/Stop” button to embroider the pattern
section.
f
When embroidering is finished, the following screen
appears. Press .
→ A screen appears so that a section of the split
embroidery pattern can be selected.
g
Repeat steps b through f to embroider the
remaining sections of the pattern.
• The pattern can be rotated 90° to either the left or
right when is pressed.
To Next Page
Loading...
