22
Feeding Tape
GETTING STARTED
Feed & Cut
This function will advance the tape approximately 0.92" (23 mm) and then cut the tape,
resulting in a blank label. This action maybe needed when installing a new tape
cassette to remove a bend in the tape and or ensure correct feeding of the tape.
Hold down the key and press the key.
"Feed & Cut?" will appear on the LCD display.
Using the or select the "Feed & Cut" option and then press either or .
The message "Feeding Tape... Please Wait" appears while the tape is fed, and
then the tape is cut.
Feed Only
This function will advance the tape approximately 0.92" (23 mm) resulting in a blank
label sticking out the tape cassette. This action is recommended when using Fabric and
Extra Strength Adhesive tapes, which should be cut using scissors.
Hold down the key and press the key.
"Feed & Cut?" will appear on the LCD display.
Using the or select the "Feed Only" option and then press either or .
The message "Feeding Tape... Please Wait" appears while the tape is fed.
Feeding Tape
1
2
To exit or cancel this function press .
1
2
To exit or cancel this function press .
To Next Page
Loading...
