TROUBLESHOOTING
29
When an error message appears on the display
When an error message appears on the display
When an error message appears on the display, follow the directions
provided below.
Message Cause/Remedy
Check # of Digits
Entered!
The number of digits entered in the bar code data does
not match the number of digits set in the bar code
parameters. Enter the correct number of digits.
Cutter Error! The tape cutter has been closed when you tried to print or
feed tape. Turn the P-touch labeler off and then on again
before continuing. When tape is tangled in the cutter,
remove the tape.
Length Limit! The length of the label to be printed using the text entered
is longer than 1 m. Edit the text so that the length of the
label is less than 1 m.
Text Too High! The text size is too large.
Text
Too Long!
The length of the label to be printed using the text entered
is longer than the length setting. Edit the text to fit within
the set length or change the length setting.
System Error XX Please contact Brother customer service.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
Need help?
General
