EMBROIDERING TUTORIAL ——————————————————————————————————————————————————
38
6
Pass the thread along the thread path
indicated on the machine, and then pass it
under the number 1 middle thread guide
plate.
1 Middle thread guide
2 Thread guide pin
• The path from the upper thread guide
around the thread tension disc and to the
middle thread guide (steps 5 through 6)
differ depending on the spool number.
Passing the thread from the left to the right
through the thread guide pins is designed to
prevent the thread from becoming tangled.
Thread each needle bar as shown in the
illustration.
7
Pass the thread along the number 1 slot to
pass it through the number 1 take-up lever
hole from right to left.
1 Thread take-up lever
8
Pass the thread down through the slot to the
lower thread guide, and then through the hole
in the number 1 lower thread guide.
1 Hole in lower thread guide
9
Use the included threader to pass the thread
into the number 1 needle bar thread guide.
1 Needle bar thread guide
2 Needle changing tool (Threader)
1
2
1
1
Sapphire_brother.book Page 38 Thursday, November 17, 2005 2:48 PM
To Next Page