Brother RJ-3050 - When Using RJ-3050 or When Not Using the Label Peeler (RJ-3150)

Setting Up the Printer
11
1
When Using RJ-3050 or When Not Using the Label Peeler (RJ-3150) 1
a Push the cover open lever to open the RD Roll compartment cover.
1 Cover open lever
b Open the roll guides by lifting up the roll guide adjustment lever (1) and pulling the roll guide outwards.
Insert an RD Roll into the RD Roll compartment with the roll feeding from the bottom as shown.
Important
• Make sure that the position of the roll guide to prevent the RD Roll from moving sideways.
• The thermal sensitive side must be on the outside of the roll and installed as shown to print properly.
1 Roll guide adjustment lever
2 Roll guide
1
2
1
1
2