What to do if loops appear in the seam of my Brother S-7200C Sewing Machine?
Loops in the seam may appear if the thread path is not smooth enough or the bobbin is not turning smoothly. Polish the thread path with a fine grain file or sandpaper. Check that there is no slackness in the thread tension by pulling out the lower thread, or replace the bobbin or bobbin case.
What causes material slippage on my Brother S-7200C?
Material slippage can occur if the presser foot pressure is too strong. Adjust the presser foot pressure.
What to do if my Brother S-7200C is trimming thread incorrectly?
If both upper and lower threads are not being trimmed, the fixed knife or movable knife may be damaged or worn. Replace the fixed knife or the movable knife.
What to do if my Brother S-7200C is trimming thread incorrectly (upper or lower thread)?
If the upper or lower thread is not being trimmed, it may be that the needle is not properly installed, or the fixed knife or movable knife is blunt. Install the needle correctly and replace the fixed knife or the movable knife.
What causes broken needles on my Brother Sewing Machine?
Broken needles can occur if the material is being pushed or pulled with excessive force during sewing, the needle is not properly installed, the needle is bent, the needle tip is broken, the needle hole is blocked, the needle and rotary hook timing is incorrect, or the needle timing is too advanced. Install the needle correctly and replace the needle. Adjust the height of the needle bar and the clearance between the needle and the tip of the rotary hook. Retard the needle timing.
What to do if my Brother S-7200C does not operate at high speed?
If the machine does not operate at high speed, the sewing speed setting or backtack speed setting may be incorrect. Use the sewing speed control keys to set the high speed.
General| Type | Industrial Sewing Machine |
|---|---|
| Model | S-7200C |
| Stitch Type | Lockstitch |
| Max Stitch Length | 5 mm |
| Motor Type | Servo Motor |
| Needle Bar Stroke | 30.7 mm |
| Lubrication | Automatic |
| LCD Screen | Yes |
| USB Port | Yes |
| Drive | Direct Drive |
| Max Sewing Speed | 5, 000 stitches per minute |
| Presser Feet | Standard |
Provides crucial safety notes regarding environmental requirements and installation procedures.
Instructions for connecting electrical cords and safety precautions.
Procedures for performing a test operation of the sewing machine using the treadle.
Detailed instructions on winding thread onto the bobbin.
Guide on how to thread the upper thread through the machine.
Guide on setting and sewing a fixed number of stitches.
Identifies keys and displays on the G10 operation panel and their functions.
How to perform start and end backtack stitches using the G10 panel.
Instructions for sewing continuous backtack stitches using the G10 panel.
How to change the needle's stop position using the G10 panel.
How to set the maximum sewing speed for the machine.
How to adjust the needle's stop position on the G10 panel.
Procedure to reset all settings to factory defaults on the G10 panel.
Guide on adjusting upper and lower thread tension for optimal stitch quality.
How to adjust the presser foot pressure for different materials.
How to adjust the length of thread left after trimming.
Instructions for adjusting the thread take-up spring position and tension.
How to adjust the vertical height of the feed dog.
Guide on adjusting the angle of the feed dog for material handling.
Procedures for synchronizing the needle and feed mechanism timing.
How to align the rotary hook with the needle for correct timing.
Common sewing problems and their possible causes and solutions.
Lists error codes, their possible causes, and troubleshooting steps.
To Next Page
