Brother S-7220B User Manual (English)

Other manuals for Brother S-7220B

Manual De Instrucciones74 pages

Parts List1 page

Basic Operation Manual28 pages

Questions and Answers:

T
Tasha AndersonSep 8, 2025
What causes lower thread tangling at the start when using my Brother S-7220B?
- M
  Mark DavisSep 8, 2025
  Lower thread tangling at the start of sewing with your Brother Sewing Machine can occur for several reasons. Ensure the bobbin spinning direction is correct when the lower thread is being pulled; it should turn in the opposite direction to the rotary hook. The bobbin winding amount should not be more that 80 %. Make sure the anti-spin spring is attached. If the bobbin is not turning smoothly, replace it. Use only bobbins which are specified by Brother.
J
Joan SchneiderSep 9, 2025
Why are there loops in the seam of my Brother S-7220B?
- C
  Christopher RobinsonSep 9, 2025
  Loops appearing in the seam of your Brother Sewing Machine may be due to a thread path that is not smooth enough; use a file with a fine grain or sandpaper to polish smooth the thread path. Alternatively, the bobbin may not be turning smoothly; pull out the lower thread to check that there is no slackness in the thread tension, or replace the bobbin or bobbin case.
G
gomezjasonSep 12, 2025
What causes incorrect thread trimming (upper or lower thread not being trimmed) on my Brother S-7220B?
- D
  Dawn SimsSep 12, 2025
  Incorrect thread trimming, where the upper or lower thread is not being trimmed on your Brother Sewing Machine, can occur if the needle is not properly installed; if it is incorrect, install the needle correctly. Also, the fixed knife or movable knife might be blunt; in this case, replace the fixed knife or the movable knife.
K
Kyle HallSep 12, 2025
Why is my Brother S-7220B Sewing Machine not trimming either the upper or lower threads?
- J
  Jeremy GarnerSep 12, 2025
  If neither the upper nor lower threads are being trimmed on your Brother Sewing Machine, the fixed knife or movable knife may be damaged or worn. Replace the fixed knife or the movable knife.
B
Billy ChanSep 14, 2025
Why does my Brother Sewing Machine stop during sewing?
- T
  Timothy TaylorSep 14, 2025
  Your Brother Sewing Machine might stop during sewing if the fixed stitch key is turned on; press the fixed stitch key so that the indicator turns off. Additionally, the power supply voltage might be too low; check the power supply. If the power cord is too long or too many appliances are being run from a single outlet, this may cause voltage drops which will in turn cause the reset function to activate and stop the machine, even if the power supply itself is normal.