BASIC TYPING
1) Move the carrierto the place you want to set a tab by using [SPACE BAR]
or [BACKSPACE].
2) Press the [ALl] + [T SET] (6) to set the tab. A maximum of 12 tabs can be
set (decimal tabs included),
3) Repeat steps 1 and 2 to set each tab stop.
• The right margin is considered a tab position.
• To replace a decimal tab (a special tab used to align numbers) with a
regular tab, first clear the decimal tab, then set a regular tab at the same
position.
• If you want to use a decimal tab as a regular tab temporad|y, simply
press [CORRECT] at the decimal tab position. This does not change
the decimal tab into a regular tab, but allows you to use that decimal
tab just like a regular tab once.
° For more details on Decimat Tabs, see page 13.
Clearing tabs
1) Using [TAB], move the carrier to the tab stop you want to clear. This may
be a regular tab or a decimal tab.
2) Press [ALT] + [T CLR] (8) to clear the tab.
CAUTION : If you press [ALl] + IT CLR] (8) for more than half a second,
all tabs will be deleted. A beep will sound three times.
Setting decimal tabs
When you want to printcolumns of numbers with their decimal pointslined up,
use the decimal tab set key.
1) To set a decimal tab, move the carrier to the place desired by using
[BACKSPACE] or [SPACE BAR].
2) Press [ALl] + [DT SET] (7) to set the decimal tab.
13
To Next Page
Loading...
