Brother TN 430 User Manual

TN 430 TONER CARTRIDGE
BROTHER
™
HL 1240 • 1650 (TN 430/460)
CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2007 UniNet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not guarantee or warrant downloaded information.
Summit Technologies is a division of UniNet Imaging Inc.
www.uninetimaging.com/technical.asp
11124 Washington Blvd., Culver City, California USA 90232 • Ph +1 310 280 9620 • Fx +1 310 280 0533 • techsupport2@uninetimaging.com
Absolute COLOR
®
• Absolute BLACK
®
• Unidrums
®
• Unirollers
®
• Uniparts
®
• Unicoatings
®
BROTHER
®
HL 1650
LASER PRINTER

Brother TN 430 Specifications

General

Brand	Brother
Model	TN 430
Category	Printer
Language	English

Summary

Brother TN-430/TN-460 Cartridge Remanufacturing Steps

Lift and Clean Developer Roller

Lift the developer roller and clean it with a lint-free cloth, avoiding solvents.

Clean Toner Hopper and Developer Blade

Discharge toner, clean hopper with air/vacuum, and clean developer blade with a dry cloth.

Reassemble and Fill Cartridge

Reassemble in reverse, fill with appropriate toner load for TN-430 or TN-460.

Remove Corona Wire Assembly Screws

Remove screws securing the corona wire assembly using a Phillips screwdriver.

Remove Drum Cleaning Assembly Screws

Remove screws holding the drum cleaning assembly (felt, recovery blade, scraper-blades).

Clean Drum Cleaning Assembly

Remove and thoroughly clean the drum cleaning assembly of all old toner.

Remove Drum Shaft Retaining Washer

Release the retaining washer from the left side to remove the drum shaft.

Extract and Clean Transfer Roller

Extract transfer roller, clean it with air/vacuum, avoiding solvents.

Mount Clutch, Spring, and Drive Gear

Slide Axle and Secure Retaining Washer

Insert and Secure Drum Cleaning Assembly

Check Electrical Continuity

Use a tester to check electrical continuity between the assembly contact and the drum shaft.