BRP Rotax 4-TEC 200 ECT - Inspections and Maintenance; Pre-Ride Inspection

23
Fault Code Menu
Fault code selection is only available if faults are active in the system.
Fault code selections:
IMPORTANT: If a fault code is present for more than three consecutive driv-
ing cycles, contact your dealer.
NOTE: The check engine light will activate on the second consecutive driv-
ing cycle when a fault is active in the engine management system.
The check engine light will turn off after 3 consecutive driving cycles without
active faults in the system.
4
6
11
53
-1
8