BRP ROTAX 916 i A Series - Standard Operation; Daily Checks; Pre-Flight Checks; Engine Start Procedure

To Next Page

To Previous Page

4) Standard operation

Topics in this chapter

4.1 Daily checks ......................................................................................... 2

4.2 Pre-flight checks ................................................................................... 5

4.3 Engine start .......................................................................................... 6

4.4 After engine start................................................................................. 12

4.5 Engine run-up ..................................................................................... 13

4.6 Engine shut-off.................................................................................... 20

Introduction

To warrant reliability and efficiency of the engine, meet and

carefully observe all the operating and maintenance

instructions.

The following description of procedures depends on the

respective type of installation in the aircraft and shall therefore

only be seen functionally.

NOTE

The control elements mentioned in this chapter are only

symbolic and should support the understanding of the

procedures. The execution of control elements is in the

responsibility of the aircraft manufacturer.

Effectivity: 916 i A / C24

Edition 0 / Rev. 1

BRP-Rotax Page 4-1

December 01 2023

Other manuals for BRP ROTAX 916 i A Series