BRUEL & KJAER 2245 - How to Add the Instrument Manually; How to Disconnect Devices

25
That's it! The instrument shows when it is connected to the mobile app.
Once the mobile app has connected to an instrument, the app will remember the instrument and re-establish a con-
nection automatically after separation.
✐ Note: Remember that measurement data is stored on the instrument. If measurement data is no longer being dis-
played after separation, tap on the mobile app to open the list of past measurements and recall the desired meas-
urement.
How to Add the Instrument Manually
If you want to find an instrument that is not showing up in the list of discovered instruments, such as an instrument on
another network, you can manually add the instrument to the list using its IPaddress.
✐ Note: Use this functionality to connect to your instrument remotely.
1.
On the mobile app, tap Add instrument manually.
2.
Enter the IP address or host name.
l For local connections, you can find the IPaddress of the instrument here:Menu > System settings > Net-
work settings > Wi-Fi settings or Ethernet settings
l For remote connections, the IP address or host name will depend on your setup. Refer to Remote Con-
nections for information about which IPaddress or host name to use
3. Tap Done.
How to Disconnect Devices
Disconnect the instrument from the mobile app if you wish to connect the mobile app to another instrument. When
you disconnect the instrument, the mobile app will not connect to the instrument automatically.
1.
In the mobile app, tap to open the instrument menu.
2.
Tap the instrument.
3. Tap Disconnect.
✐ Note: If you disconnect the instrument from the mobile app, the app will still discover the instrument.
Get Started: Connect the Mobile App to the Instrument