BRUEL & KJAER 2245 - Electrical Frequency Responses

44
About Data View
About data view displays information about the instrument with which you are measuring. It can also include the loc-
ation of the instrument (latitude and longitude) using GPS (global positioning system).
To enable latitude and longitude coordinates in the About data view:
1.
Enable Service mode on the instrument.
a.
Press briefly to open the menu.
b. Go to: System settings > Advanced settings > Service mode.
c. Select Enabled.
2. Using the instrument or the mobile app, go to:System settings > Advanced settings > GPS location.
3. Select Enabled.
✐ Note: To enable latitude and longitude coordinates in the About data view using the mobile app, Service mode must
be enabled on the instrument.
Voltage Output
The USB-C socket is the output channel. Use an output cable such as AO-0846 to collect the signal.
To set up the instrument to generate an output signal:
1.
Open the menu.
l
On the instrument: Press briefly to open the menu.
l
On the mobile app:Tap to open the instrument menu.
2. Go to: System settings > Voltage output > Source.
3.
Select:
l Input X-weighted for listening purposes
l LXF as 10 mV/dB
X corresponds to the frequency weightings that are enabled in Measurement settings.
Set up the Instrument: Voltage Output