BRUEL & KJAER 2245 - Measurement Ranges

56
How to Add an Instrument using Its IP Address
If you want to find an instrument that is not showing up in the list of discovered instruments, such as an instrument on
another network, you can manually add the instrument to the list using its IPaddress.
✐ Note: Use this functionality to connect to your instrument remotely.
1.
In the import dialog, click .
2. Select Add instrument from IP address.
3.
Enter the IP address or host name.
l For local connections, you can find the IPaddress of the instrument here:Menu > System settings > Net-
work settings > Wi-Fi settings or Ethernet settings
l For remote connections, the IP address or host name will depend on your setup. Refer to Remote Con-
nections for information about which IPaddress or host name to use
How to Store a Backup
You can set up your instrument to store backups of your data to a USBstick or network storage (either a network
attached storage (NAS) device or a shared folder). Data transfers automatically when the storage device is available and
an icon on the instrument indicates the status of the backup.
Network Storage
You will need:
l Network storage
l Your instrument
✐ Note: If you are using NAS, you will need to set it up according to the manufacturer's instructions first.
Procedure:
1. Go to: Menu > System settings > Data management > Backup settings > Backup.
2. Select Disabled.
3. Enter the host name or IP address of the device or network (so the instrument can find it).
4. Enter the user name and password (so the instrument can access the device or network).
5. Specify the path (so the instrument knows where to upload the data.)
6.
Specify the domain if the network belongs to a domain.
7. Set Backup to Network storage.
Transfer Data : How to Add an Instrument using Its IP Address