Bruker S1 TITAN - Page 42

S1 TI
TAN, T
RACER
5, and CTX
User Manual
030.0112.04.0
42 of 67
Phase leng
th
To man
ually set the length of each
phase –
Step
Act
ion
Result
1
From th
e
Read
y to Test
screen, tap SET
TINGS
.
The SET
TINGS
screen is dis
played.
2
Ensur
e that
Use Defa
ult Settings
box is n
ot
checked.
If it checked, tap it.
Phase opti
ons are displayed.
3
Ensur
e
the box
below
Unlimited is unch
ecked
.
The bo
x is empty and
field
s
previ
ously
grayed out are available.
4
Set each phase duration in seconds by tapping
either th
e minus sign (-) or the plus sign (+) to
decrease or increase, respectively, the
measurement duration.
OR
Tap the field.
The field reflects the number change.
OR
A numeric keyboard is displayed.
5
On the
keyboard, tap a number and
OK.
The keyb
oard is removed and the field
reflects the number change.
6
For subs
equent phases, repeat steps 3
-5.
To disable subsequent phases, set duration
to 0.
7
Tap OK.
The Setting
s are saved and the
Read
y
to Test
screen is displayed.
One ph
ase
If a meth
od does not use
mul
tiple
phases, only o
ne phase is displayed.
Unlimited
Unli
mited
indi
cates
the
measurement
contin
ues
while
the trigger is pressed and ends when the
trigger
is released. It is not a timed measurement but is limited to 300 seconds.
If Unlimited is checked for a phase, the instrument will NOT use that phase or additional phases.
First resul
t
The inter
val in seconds between the start of
an assay
and when
the First
Result
disp
lays
can be
set manu
ally. This assures that results from shorter, less accurate test times are not displayed.
First tes
t
The time
can be set manually before the
Fir
st
Test dis
plays and records
. Lo
nger test times
are
mor
e accurate. First Test settings must always be as long as, or longer, than First Result times.
Results of the first test are compared to the Grade Library and, if a match is found, the grade ID is
displayed.
Activate beep
This checkbox determin
es if
an audi
ble alarm
sound
s when
a grad
e match
is found
.
Trigger
options
Ma
nual Trigger Active
– The instr
ument
operates
while
the trigger
is pressed
or until safety
criteria are exceeded.
Auto Trigger Active – The measurement begins when the trigger is pressed and released. Analysis
time is controlled by defined phase durations. The measurement can be stopped at any time by
pressing and releasing the trigger again. This option is not available in all markets.
Your Complete Source for
Testing Equipment
www.BergEng.com
Berg Engineering & Sales Company, Inc.
1-847-577-3980
Info@BergEng.com