16 [EN]
6. OPERATING INSTRUCTIONS
ATTENTION
- Operate the dehumidifier only in the upright position.
- Plug in to a standard outlet with the correct voltage and amperage for the unit.
- Allow five minutes before restarting after the unit shuts off for any reason. This will avoid damaging the compressor.
- Check dehumidifier daily for correct operation.
- Protect floor surfaces from water.
Please proceed as follows to start using this dehumidifier:
After transported, the dehumidifier should be allowed to stand for 30 minutes. This procedure is recommended
to extend the compressor’s operating lifetime.
Put the plug into the socket.
Check that the water tanks are in position.
The operating indicator (2 – green light) must be illuminated after plugging in the unit to the mains.
Press the ON/OFF key (1) and start the device.
After a short start-up phase, the current room humidity is shown on the display (6).
Set the electronic humidistat (4 - +/- key) to the desired humidity level.
Check for the proper operation of both fan and compressor before leaving the unit unattended.
To Next Page
Loading...