EasyManua.ls Logo

Brune HP50 - Troubleshooting

Brune HP50
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22 [EN]
13. TROUBLESHOOTING
Trouble
Cause
Solution
Unit does not operate
No power to the unit
Plug in the unit; check power at outlet
Water tank must be emptied and
installed again
Completely filled water tank
Doesn’t dehumidify
Ambient temperature is lower than
+5°C
Under this condition the dehumidifier becomes
inefficient. It is recommended to switch off the
dehumidifier
Ambient temperature exceeds 32°C
Under this condition the compressor is
overloaded and switches off automatically. It is
recommended to switch off the dehumidifier.
The ambient air humidity is lower
than 35 %
Under this condition the dehumidifier becomes
inefficient. It is recommended to switch off the
dehumidifier
The air filter is strongly soiled
The air filter must be exchanged
Not enough time to dry
Allow more time to dry
Compressor will not
start
Overload protector is defective
Consult reseller or authorized workshop
The fan is out of
operation
Fan not running
Consult reseller or authorized workshop
Unit continuously in
defrost and you can
see an ice block on the
evaporator
Defective control assembly
Consult reseller or authorized workshop
The room temperature is lower
than +5°C
Assure that the device is only set up in rooms
with temperatures above +5°C.
Defective bypass relay valve
Consult reseller or authorized workshop
Unit does not defrost
Defective temperature sensor
Consult reseller or authorized workshop
Defective control assembly
Consult reseller or authorized workshop
Defective bypass relay valve
Consult reseller or authorized workshop
The display shows 0.5.
No radio signal
Check signal from radio humidity transmitter /
replace batteries
Continuous operation is set
(SET-value 30%)
The display shows 0.6.
The internal sensor is defective.
Consult reseller or authorized workshop
C.O.
The sensor on the condenser is
defective.
Consult reseller or authorized workshop
E.P.
The sensor on the evaporator is
defective.
Consult reseller or authorized workshop
O.H.
Overheating of the capacitor.
Please switch off the device and let it cool down.