43
6.3.3.9. Furnace G-Terminal Alert
Use the alert function to select the contact state for an alert. Select
Normally Open or Normally Closed, and then save your selection.
A13230
Shutdown: This setup option selects the change of state required for
shutdown. Select Normally Open or Normally Closed, and then save
your selection.
6.3.3.10. Furnace G Terminal Alert Label
Once the G Terminal Alert label has been entered, it is shown both on the
main screen and in the notification email when the alert becomes active.
A170248
6.3.4. AC/Heat Pump
First touch SETUP, then touch AC/HEAT PUMP to set up the
parameters for the AC/Heat Pump unit.
To Next Page
Loading...
