If you need some help, call us on 0800 218 2182* or go to bt.com/producthelp
19
Auto end
By default, auto end is set to
On, so you can end a call just
by putting the handset back in
the base.
If auto end is set to Off, you’ll
need to press to end the call.
Auto end On is the default
setting. See page 51.
If you switch the phone off
and on again, the phone will
need to be charged for some
time, before the true charge
status can be recalculated
by the phone and accurately
displayed.
Make an external call
1. Press .
2. When you hear the dial tone, enter the number.
Preparatory dialling
1. Enter the number first. If you make a mistake select
Del.
by pressing the Right option button to
delete the last digit.
2. Press to dial.
End a call
1. Press .
To switch the handset off
1. Press and hold until the handset turns off.
To switch the handset on
1. Press and hold until the handset turns on.
Using the phone
When you make a call, the In use
light on the base comes on.
Call timer
Your handset will automatically
time your outgoing and
incoming calls. The handset
shows the length of time both
during and for a few seconds
after your call.
To Next Page
Loading...